2015 Chevrolet Trax · 1.4L LUV manual
2015 Chevy Trax Serpentine Belt Diagram and Replacement
The inspected 2015 Trax manuals list the 1.4L LUV drive-belt procedure under LS, LT, and LTZ selections in FWD and AWD. Their Notes, Removal, and Installation leaves matched across all six checked selections. Choose the selection that matches your vehicle and confirm the engine by VIN before service.
Engine support and mount removal are part of this job
The checked removal procedure calls for right front wheelhouse-liner removal, an engine support fixture, and right-side engine-mount removal before releasing the tensioner. Do not remove the mount without safely supporting the engine. Use the full applicable manual procedure and a qualified shop if you lack the equipment.
Choose your 2015 Trax manual
Each selection links to its own source procedure leaves. Read Notes, Removal, and Installation together; the routing figure and tool positions are shown on the applicable manual pages.
2015 Trax LS, AWD · 1.4L LUV
2015 Trax LT, FWD · 1.4L LUV
2015 Trax LT, AWD · 1.4L LUV
2015 Trax LTZ, FWD · 1.4L LUV
2015 Trax LTZ, AWD · 1.4L LUV
The LS FWD Accessory Drive Components figure identifies the generator and A/C compressor belt in the source manual. Compare that drawing with your engine and equipment before following its routing.
Tools and belt fitment
The checked Notes leaf names EN-48488 holding wrench and EN-955 locking pin. It refers to its Special Tools section for regional equivalents. The source calls for the holding wrench to unload the tensioner and the locking pin to hold it; follow its installation instructions to release the tensioner slowly. Verify equivalent tools and belt fitment using the VIN.
As an Amazon Associate, AllOEMManuals earns from qualifying purchases. These are search results, not confirmed fitment matches.
Scope: inspected 2015 Trax 1.4L LUV manuals. This page does not establish a procedure or belt fit for another engine or model year.