2009 ZAP XLFACTORY OEM SERVICE PROCEDURE

Assembly Sequence Chart, Including Possible Problem Areas

Fig 1: Exploded View Of Steering Gear
G00498381Courtesy of LIUZHOU WULING SPECIAL PURPOSE VEHICLE MANUFACTURING CO. ,LTD
  1. Assemble new ball bearings into steering gear wheel (pinion shaft).
  2. Fig 2: Installing Ball Bearing
    G00498390Courtesy of LIUZHOU WULING SPECIAL PURPOSE VEHICLE MANUFACTURING CO. ,LTD
  3. Assemble the gear ring into steering gear wheel (pinion shaft) with snap ring pliers.
  4. Fig 3: Installing Bearing Retaining Ring
    G00498391Courtesy of LIUZHOU WULING SPECIAL PURPOSE VEHICLE MANUFACTURING CO. ,LTD
  5. Assemble the steering gear wheel onto the steering gear housing with a rubber hammer.
  6. Fig 4: Installing Pinion Shaft
    G00498392Courtesy of LIUZHOU WULING SPECIAL PURPOSE VEHICLE MANUFACTURING CO. ,LTD

    Attention:Β  Always knock gently when mounting the steering gear wheel.

  7. Assemble new retainer ring with a snap ring pliers.
  8. Fig 5: Installing Retainer Ring
    G00498393Courtesy of LIUZHOU WULING SPECIAL PURPOSE VEHICLE MANUFACTURING CO. ,LTD
  9. Assemble the oil seal onto the steering gear housing.
  10. Attention:Β  Make sure the interface between the oil seal and steering gear housing is free of grease lubricant.

    Fig 6: Installing Oil Seal
    G00498394Courtesy of LIUZHOU WULING SPECIAL PURPOSE VEHICLE MANUFACTURING CO. ,LTD
  11. Assemble the steering rack into the steering gear housing.
  12. Attention:Β  Apply grease lubricant on the whole outer surface and teeth surface of grease steering rack. Do not damage steering rack bushing when assembling.

    Fig 7: Inserting Steering Rack Into Housing
    G00498395Courtesy of LIUZHOU WULING SPECIAL PURPOSE VEHICLE MANUFACTURING CO. ,LTD
  13. Assemble the adjusting plug block.
  14. Fig 8: Installing Adjusting Plug Block
    G00498396Courtesy of LIUZHOU WULING SPECIAL PURPOSE VEHICLE MANUFACTURING CO. ,LTD
  15. Assemble the adjusting spring.
  16. Starting torque adjusting system.
    1. Screw down the steering rack with a spanner wrench to adjust the plug. Tightening torque is 11-15 Nm.
    2. After step a), return the plug back to a position of 45Β°-55Β°. Measure the starting torque with a torque wrench. Repeat step a) to step c) if measurement doesn't meet specified starting torque of 1.5-1.6 Nm.
    3. Screw down the adjustable plug to a specified torque of 35-45 Nm
    4. Remeasure starting torque of 1.5-1.6Nm.
  17. Fig 9: Turning Adjusting Plug
    G00498397Courtesy of LIUZHOU WULING SPECIAL PURPOSE VEHICLE MANUFACTURING CO. ,LTD
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.