Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 ZAP XLFACTORY OEM SERVICE PROCEDURE
Function Description
- After starting, the default is electric power display;
- When the ignition switch is in "ON" position, display can be changed by pressing the button, in this order: electric capacity → discharge power → current of power battery → start battery voltage → electric capacity
- Display of failure code; When there is failure on vehicle, the multi-function display will continuously alarm and partial failure information will be displayed
- Charging Cue Light; When power battery needs charging, this charging cue light is intermittent and/or bright. Intensity increases as battery capacity gets lower.
- Multi-function display also provides speedometer and odometer
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.