Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Yugo GVFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Front | |||
| Camber in Degrees | |||
| Fraction | 1 +/- 1/2 | ||
| Decimal | 1.00 +/- .50 | ||
| Caster in Degrees | |||
| Fraction | 2 1/4 +/- 1/4 | ||
| Decimal | 2.25 +/- .25 | ||
| Toe-In in Inches | |||
| Fraction | 0 +/- 1/32 | ||
| Decimal | 0 +/- .03 | ||
| Toe-In in Degrees | |||
| Fraction | 0 +/- 1/16 | ||
| Decimal | 0 +/- .06 | ||
| Rear | |||
| Camber in Degrees | |||
| Fraction | -3 | ||
| Decimal | -3.0 | ||
| Toe-In in Inches | |||
| Fraction | 3/16 +/- 1/16 | ||
| Decimal | .19 +/- .06 | ||
| Toe-In in Degrees | |||
| Fraction | 3/8 +/- 1/8 | ||
| Decimal | .38 +/- .13 | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
