Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition System: Operation
A trigger wheel turns with the distributor shaft. As each trigger wheel tooth approaches and passes the pole of the magnetic pick-up coil, the magnetic field created by the permanent magnet concentrates, strengthens and collapses. As the tooth passes the pick-up pole, the magnetic field collapses, This induces a low-voltage alternating current in the windings of the pick-up coil.
This low voltage signal passes to the control module, which makes or breaks the primary ground circuit of the ignition coil, depending upon the polarity of the pick-up coil signal. This induces a high voltage surge in the coil secondary windings that fires the spark plugs. Control module also controls the dwell angle (coil build-up time measured in distributor degrees).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.