Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1987 Yugo GVFACTORY OEM SERVICE PROCEDURE

Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application

Specification

GV & GVX

Front

Camber in Degrees

Fraction

1 1/2 +/- 1/2

Decimal

1.500 +/- .500

Caster in Degrees

Fraction

2 1/4 +/- 1/2

Decimal

2.250 +/- .500

Toe-In in Inches

Fraction

N/A

Decimal

N/A

Toe-In in Degrees

Fraction

N/A

Decimal

N/A

Toe-Out in Turns

Inner

⁽¹⁾

Outer

⁽¹⁾

Steering Axis Inclination (SAI)

⁽¹⁾

Rear

Camber in Degrees

Fraction

-1/2 +/- 1/2

Decimal

-.500 +/- .500

Caster in Degrees

Fraction

N/A

Decimal

N/A

Toe-In in Inches

Fraction

3/16 +/- 1/16

Decimal

.188 +/- .063

Toe-In in Degrees

Fraction

3/8 +/- 1/8

Decimal

.375 +/- .125

Toe-Out in Turns

Inner

⁽¹⁾

Outer

⁽¹⁾

Steering Axis Inclination (SAI)

⁽¹⁾

⁽¹⁾	Information not available.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.