2021 Volvo S90 T6 R-DesignFACTORY OEM SERVICE PROCEDURE

OBD Firewall Module (OFM) [2018-2021]: Removal

Remove front seat. Refer to: [FRONT SEAT]

GLL1004822Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

GLL1030085Courtesy of VOLVO CARS CORPORATION

Fold marked part aside.

GLL1016728Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

GLL1027150Courtesy of VOLVO CARS CORPORATION

Release the locks.

Remove the marked part.

GLL1016939Courtesy of VOLVO CARS CORPORATION

Depress the locking device.

Disconnect the connector.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.