2018 Volvo V90 T5 R-DesignFACTORY OEM SERVICE PROCEDURE

Converter Dc/Dc (Direct Current): Removal

NOTE:

Removal steps in this procedure may contain installation details.

GLL1024020Courtesy of VOLVO CARS CORPORATION
NOTE:

Orientation view

Remove the plenum cover. Refer to: [PLENUM COVER]

GLL1031407Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Torque:  M6, 10Nm

GLL1007500Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Torque:  Bracket, to Secondary bulkhead panel, 2.5Nm

GLL1030485Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Torque:  M8, 24Nm

GLL1003813Courtesy of VOLVO CARS CORPORATION
  1. Fold marked part aside.
  2. Remove the marked part.

Follow the instructions regarding disconnection and connection. Refer to: [BATTERY DISCONNECTING AND CONNECTING]

Drain the cooling system. Refer to: [COOLING SYSTEM - DRAINING, CHARGING AND BLEEDING]

GLL1047351Courtesy of VOLVO CARS CORPORATION
NOTE:

Use suitable paper to absorb any escaping fluid.

Undo the hoses from the connections.

GLL1047130Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Remove the marked part.

Torque:  M6, 10Nm

GLL1042277Courtesy of VOLVO CARS CORPORATION

Disconnect the connector.

GLL1046031Courtesy of VOLVO CARS CORPORATION

Remove the nuts.

Loosen the wiring harness or move it to the side.

Torque:  M6, 10Nm

GLL1044460Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Remove the marked part.

Torque:  M6, 10Nm

GLL1044834Courtesy of VOLVO CARS CORPORATION
NOTE:

Ensure that the component has been drained of fluid.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.