2016 Volvo XC60 T6 R-DesignFACTORY OEM SERVICE PROCEDURE

Component Specifications

SHIFT SOLENOIDS 

GLL173489Courtesy of VOLVO CARS CORPORATION
Component  Note  Resistance (Ω) 
Gear shift solenoid S1, S2 Resistance between the solenoid pins and the solenoid casing/transmission housing. +20°C = 11-15 Ω

Other values, see diagram. When measuring at other temperature than +20 °C the check-measurement shall be performed at +20 °C. This is to ensure if the resistance is correct or not.

LINEAR PRESSURE SOLENOID SLT AND LOCK-UP SOLENOID SLU 

GLL173491Courtesy of VOLVO CARS CORPORATION
Component  Note  Resistance (Ω) 
Lock-up solenoid (SLU)
Linear pressure solenoid (SLT)
Resistance between solenoid pins. +20 °C= 5.0 - 5.6 Ω

Other values, see diagram. When measuring at other temperature than +20 °C the check-measurement shall be performed at +20 °C. This is to ensure if the resistance is correct or not.

LINEAR PRESSURE SOLENOID SLB1, SLC1, SLC2, SLC3 

GLL173490Courtesy of VOLVO CARS CORPORATION
Component  Note  Resistance (Ω) 
Linear pressure solenoid (SLB1), (SLC1), (SLC2), (SLC3) Resistance between solenoid pins. +20 °C= 5.0 - 5.6 Ω

Other values, see diagram. When measuring at other temperature than +20 °C the check-measurement shall be performed at +20 °C. This is to ensure if the resistance is correct or not.

OIL TEMPERATURE SENSOR 

GLL141860Courtesy of VOLVO CARS CORPORATION
Component  Note  Resistance (Ω) 
Oil temperature sensor Resistance between the temperature sensor terminals. +10 °C = 5587 - 7303 Ω
+25 °C≈ 3500 Ω
+110 °C = 223 - 271 Ω

Resistance decreases with increasing temperature.

A test measurement must be taken at both temperatures. This is to establish if the resistance is correct or not.

SOLENOID P-POSITION LOCKOUT 

GLL154583Courtesy of VOLVO CARS CORPORATION
Component  Note  Resistance (Ω) 
Solenoid p-position lockout Resistance between the solenoid's connections +20°C = 35-37 Ω
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.