2016 Volvo XC60 T6 R-DesignFACTORY OEM SERVICE PROCEDURE

Control Panel Comfort Functions Rear (Certain Versions Only)

GLL1029118Courtesy of VOLVO CARS CORPORATION

The control panel is located between the rear seats and contains switches for the following functions:

  • Rear seat tilt forward/backward (Ignition position II)
  • Sun curtain, rear window forward/backward (Ignition position II)
  • Passenger seat length adjustment forward/backward (Unlocked position)
  • Seat massage rear (three active positions) (Engine running)
  • Seat ventilation rear (three active positions) (Engine running)
  • Seat heating rear (three active positions) (Engine running)

The switches' positions for massage, seat ventilation and seat heating are sent by LIN communication to the Rear Seat Executive Module (RSX). Switch for backrest tilt rear has separate signal cables to the Rear Seat Executive Module (RSX). Switch for length adjustment (backwards-forwards) of the passenger seat as well as sun blind is hard-wired directly to each electric motor.

General interior lighting in the control panel rear seat functions is supplied by the comfort lighting via the Central Electronic Module (CEM) and is active when the vehicle is unlocked.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.