2016 Volvo S80 T5FACTORY OEM SERVICE PROCEDURE

Test Phases, Quick Test Fuel Tank System

REFERENCE 

Reference phase for leakage, and operating check of the leak diagnostic unit (DMTL), is in progress.

If no fault is detected during this phase, the check for major leakage starts.

If a fault is detected during this phase the test is stopped and the parameter "DMTL, test status" shows "Fault Found". The diagnostic trouble code (DTC) for the detect fault is stored in the Engine control module (ECM).

MAJOR LEAK 

Investigation of the fuel tank system in progress.

If no fault is detected during this phase, the check for minor leakage starts.

If leakage is detected during this phase the test is stopped and the parameter "Tank system test result" shows "Major leak found". The diagnostic trouble code (DTC) is stored in the Engine control module (ECM).

MINOR LEAK 

Investigation of the fuel tank system in progress.

If leakage is detected during this phase the test is stopped and the parameter "Tank system test result" shows "Minor leak found". The diagnostic trouble code (DTC) is stored in the Engine control module (ECM).

NOT IN PROGRESS 

Leakage diagnosis not in progress. Quick-test tank system has not started, has been finished, or has been blocked.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.