Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Switches On The Keypad
Climate control module (CCM) is available in two versions from and including structure week 201020. The keypads' design differ but can, in principle, in both cases be divided into three parts.
The switches on the lower part of the keypad control optional functions such as "Lane Departure Warning" and active safety. On the latter version of Climate control module (CCM) the switches for optional functions are in turn divided in two groups: the first consists of the three middle switches (A), which are replaceable; the second group consists of the three surrounding switches (B), which are fixed.
Above the switches for optional functions, in the middle of the keypad, are switches that affect functions in Climate control module (CCM) (4/6), for example:
- climate control
- activation of the seat heaters
- etc.
The keypad's top group of switches concerns functions for the infotainment system. When activating of these switches Climate control module (CCM) sends a signal to Infotainment control module (ICM) (3/281) via the CAN.
When activating switches on the keypad the Climate control module (CCM) will activate light-emitting diodes even if the function for some reason should not be available.
For more information, see DESIGN AND FUNCTION - INFOTAINMENT CONTROL MODULE (ICM) .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
