2016 Volvo S60 T6FACTORY OEM SERVICE PROCEDURE

Output Speed

the value displays the output speed (RPM). The transmission control module (TCM) receives a signal from the transmission speed sensor which is affected by a toothed wheel on the output shaft. The value can be compared with the calculated value from the brake control module (BCM).

Measurement range: 0 - 15 000 RPM.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.