2013 Volvo XC70 T-6FACTORY OEM SERVICE PROCEDURE

Other Information

Replacement of the battery (main battery)/ battery monitoring sensor 

For replacing the battery (main battery) or battery monitoring sensor, battery information must be reset. See: VIDA/DIAGNOSTICS/VEHICLE COMMUNICATION/CEM/Advanced.

The vehicle's battery (main battery) is completely discharged or the battery monitoring sensor has been disconnected from the battery pole. 

If the battery (main battery) has been completely discharged so that the vehicle does not react to the ignition key (in principle, is completely dead) and the vehicle is then started using an external auxiliary battery or battery charger, the battery monitoring sensor can interpret this as it being disconnected from the battery (main battery). The battery monitoring sensor then reads off the battery voltage and assumes a SoC that is proportional to the voltage. If the SoC is low, the automatic start/stop of the engine function is not permitted.

NOTE:

For the battery monitoring sensor to calculate the main battery's correct state of charge the vehicle must be in sleep mode for 4 hours. Sometimes, 6 hours in sleep mode may be required. This is on the condition that the ignition key has been removed, doors and hatches closed and the car is locked. If the SoC is still low, the automatic start/stop of the engine function will not be permitted. The battery (main battery) then needs to be charged.

Charging battery (main battery) 

When the external auxiliary battery or battery charger is temporarily connected, the battery's (main battery) negative pole must never be used for connection, only the vehicle's chassis must be used as an grounding point. When connected correctly, the battery monitoring sensor registers how much current the battery (main battery) is charged with and can then calculate the battery's (main battery) correct SoC.

Secondary battery relay always activated/closed 

If the vehicle's battery (main battery) is disconnected with the ignition off and the secondary battery relay is continuously activated/closed for some reason, the vehicle will still be powered.

To check this, connect the battery's (main battery's) negative pole. Then try switching on the ignition. If the vehicle's ignition can be switched on, there is probably a fault in the secondary battery circuit.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.