Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Functions
Information for the automatic start/stop of the engine function can be readout via diagnostics. Parameters to read, components to activate etc.
See VIDA - DIAGNOSTICS/VEHICLE COMMUNICATION, for the following control modules:
- Engine control module (ECM)
- Central electronic module (CEM)
- Climate control module (CCM)
The Engine control module (ECM) detects and stores information about which causes can block the automatic start/stop of the engine function and which causes can cause the system to request autostart when the vehicle is in autostop mode. See: VIDA - DIAGNOSTICS/VEHICLE COMMUNICATION/ECM/Advanced.
Central electronic module (CEM)Β
For descriptions of parameters, see: Description of parameters - Central electronic module (CEM)
For descriptions of activations, see: Description of activations - Central electronic module (CEM)
Engine control module (ECM)Β
For descriptions of parameters, see: Description of parameters - Engine control module (ECM)
For descriptions of activations, see: Description of activations - Engine control module (ECM)
For descriptions of reasons for blocking of autostop, See VIDA - INFORMATION/SPECIFICATIONS/SPECIFICATION, MISC
For descriptions of reasons for system requested autostart, See VIDA - INFORMATION/SPECIFICATIONS/SPECIFICATION, MISC
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
