Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Volvo C70FACTORY OEM SERVICE PROCEDURE
Quick Lookups: Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Compressor Oil | 7.00 OZS. | 0.2 L | PAG 46 | S | |||
| Air Cond Refrigerant | 1.20 LBS. | 0.54 KG | R-134a | S | |||
| Automatic Transmission Fluid | 8.14 QTS. | 7.7 L | JWS 3309 | S | |||
| Brake Fluid | 0.63 QTS. | 0.59 L | DOT 4+ Brake Fluid | S | |||
| Engine Coolant | Automatic Trans | 10.50 QTS. | 9.93 L | 50/50 mixture of VOLVO Antifreeze/Coolant and water | S | ||
| Engine Oil | w/Filter | 6.10 QTS. | 5.77 L | Full Synthetic engine oil meeting the minimum ACEA A5/B5 must be used, SAE 5W-30 | Incorrect viscosity oil can shorten engine life under normal use. SAE 5W-30 will provide good fuel economy and engine protection. Volvo oil VCC RBS0-2AE/SAE 0W20 is recommended for extreme driving conditions. | S | |
| Fuel Tank | 15.90 GALS. | 60.18 L | S | ||||
| Power Steering Fluid | 1.30 QTS. | 1.23 L | Power Steering Fluid (WSS M2C204 A) or equivalent | System and reservoir combined. | S | ||
| Windshield Washer Fluid | 4.20 QTS. | 3.97 L | Reservoir should be filled with water and solvent (winter time: windshield washer antifreeze). | S | |||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.