2012 Volvo XC90 R-Design, FWDFACTORY OEM SERVICE PROCEDURE

Transmission Fluid, Replacing: Refilling

Apply the parking brake. Move the gear selector lever to position P.

Fill with approximately 2 liters of oil.

Start the engine. Allow the engine to idle.

Turn the engine off when air bubbles start to become visible in the hose.

Fill with approximately 2 liters of oil.

Start the engine again and let it idle.

Turn the engine off when air bubbles start to become visible in the hose.

Remove the hose from the oil cooler hose. Detach it from the connection to the cooler. Install the hose in the normal position on the cooler and the transmission.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.