2012 Volvo XC90 R-Design, FWDFACTORY OEM SERVICE PROCEDURE

Transmission Input Speed Sensor (Speed Of The Input Shaft)

Fig 1: Identifying Transmission Speed Sensor
GLL101514Courtesy of VOLVO CARS CORPORATION

The transmission input speed sensor, (input shaft speed) is positioned in the transmission housing. The sensor is an active sensor and is supplied with 12 V. When the driven gearwheel rotates, the sensor generates a pulsed current (quadratic wave) where the strength of the current depends on the position of the pulse wheel. The signals from the coil in the sensor are then effected by a magnetic resistance element, which generates a current which oscillates between 7 mA and 14 mA, and the frequency of which increase with speed. The transmission control module (TCM) calculates the transmission input speed using the signal from the sensor.

The input speed is compared with the transmission output speed from the transmission speed sensor signal to calculate the gear ratio.

There are diagnostics for the transmission input speed sensor.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.