2012 Volvo XC90 R-Design, FWDFACTORY OEM SERVICE PROCEDURE

Key Position, Status

The status indicates the position of the ignition key when the diagnostic trouble code (DTC) was stored.

No key = no key in the ignition switch.

Position 0 = ignition key in position 0.

Position 1 = ignition key in position 1.

Position 2 = ignition key in position 2.

Position 3 = ignition key in position 3.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.