2012 Volvo XC90 R-Design, AWDFACTORY OEM SERVICE PROCEDURE

Engine General: B5254T2

General 

Fig 1: Identifying B5254T2 Power/Torque Chart
GLL107744Courtesy of VOLVO CARS CORPORATION
  • Based on the B5244T3
  • There have been a number of changes to the engine, resulting in improved performance and lower emissions
  • A modified length of stroke results in a cylinder capacity of 2521 cm3 .
  • Meets the emissions requirements for EURO 2005 (EURO 4) and ULEV II
  • The maximum torque of 320 Nm is reached at 1500 rpm
  • Maximum power is 154 kW (210 hk) at 4800 rpm
  • Engine management system Bosch ME 7.01
  • The start sequence is based on the Wide Range concept.

General, continued 

Fig 2: Identifying B5254T2 Engine Components
GLL107745Courtesy of VOLVO CARS CORPORATION

Crankshaft, crankshaft bearing 

Stroke of 93.2 mm. Forged. Weight: 21559 grams. Connecting rod pins: Ø 50.00 mm. Main bearing journals: Ø 65.00 mm.

Both the upper and lower crankshaft bearings are aluminum. The upper bearing has a lubrication hole.

Connecting rods, connecting rod bearing 

Forged connecting rods with split covers. Length center to center = 145 mm. Weight = 634 grams.

Both the upper and lower bearings are aluminum.

Pistons 

Graphite coated pistons.

Diameter/length gudgeon pin = 21 mm/60 mm.

Cylinder head, camshafts 

Cylinder head with CVVT (Continuous Variable Valve Timing) for both the intake and exhaust camshaft.

Change over angle CVVT:

  • intake = 50 crankshaft degrees
  • exhaust = 30 crankshaft degrees.

Other 

Flame trap with labyrinth.

Modified manifold providing improved gas flow and more exhaust energy to the turbine in the turbocharger (TC). Gives a quicker turbocharger response.

The camshaft toothed belt is reinforced to increase service life. The belt tensioner has a new gasket to ensure an optimal seal.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.