2012 Volvo XC90 Base, FWDFACTORY OEM SERVICE PROCEDURE

Automatic Rear View Mirror Anti-Dazzle

The upper electronic module receives data from two photo sensors, one on the front and one on the reverse of the rear view mirror. If the upper electronic module determines that the anti-dazzle function is required, a signal is sent to the electro-chromatic mirror which diffuses to the level required.

The signal transfer occurs internally in the rear view mirror, and is carried out directly between the upper electronic module and the anti-dazzle function.

CAUTION:

The rear view mirror with automatic anti-dazzle can only be installed in the factory. Upgrading to, or removing an anti-dazzle rear view mirror cannot be carried out after market due to software limitations.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.