2012 Volvo XC90 Base, FWDFACTORY OEM SERVICE PROCEDURE

Explanation Of Dimensions

Fig 1: Body Dimension Measuring Point Symbols
GLL103313Courtesy of VOLVO CARS CORPORATION

The dimensions in the table are listed as follows:

Symbol number 1 means that the measurement is taken from the center.

Symbol number 2 means that the measurement is taken from one edge.

GLL103386Courtesy of VOLVO CARS CORPORATION

Symbol number 3 means that the measurement is taken from a cut mark. Measurements are taken from the bottom of the recess as shown.

If only one measuring point symbol is displayed, the symbol applies to both measuring points. Otherwise the symbols are shown on each side of the dimension shown.

Fig 2: Windshield Opening Measurement Locations (1 Of 3)
GLL103374Courtesy of VOLVO CARS CORPORATION

C1 = 1125 mm

C2 = 1445 mm

C3 = 1368 mm

C4 = 1479 mm

Fig 3: Windshield Opening Measurement Locations (2 Of 3)
GLL103375Courtesy of VOLVO CARS CORPORATION
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.