Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Linear Pressure Solenoid And
The linear pressure solenoids and are located in the transmission control system, which is fitted on the front edge of the transmission. The designation of the solenoid is linked to the component (clutch/brake band) that the solenoid controls. The linear pressure solenoids consist of an electrical coil that controls a hydraulic valve. The solenoids are controlled with a pulse width modulated (PWM) voltage and are grounded via the transmission control module (TCM). The solenoids have a linear hydraulic function. The hydraulic valves are controlled by the varying current resulting from the current pulse ratio. With a high pulse ratio, i. e. high current strength (approx. 1 A), the system pressure is low. With a low pulse ratio, i. e. low current strength, the system pressure is high. In the event of an open circuit the system pressure is at a maximum, resulting in hard shifting. Here, the hydraulic valve is fully open.
The solenoids can be diagnosed.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
