2012 Volvo XC90 Base, AWDFACTORY OEM SERVICE PROCEDURE

Engine Torque

The transmission control module (TCM) requests torque-limiting from the engine control module (ECM) in order to limit torque immediately before shifting. The signal is used to inform the ABS control module when the driver has requested torque reduction. This is so that the torque will return to the correct level after reduction.

Measurement range: -512 - +511 Nm

511 = No torque limiting request

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.