Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Gear-Shift Position Sensor Position
P/R/N/D/4/3/L = normal gear positions.
OR/OD/OL = Undefined R, D or L positions. The signals from the gear-shift position sensor are outside the normal range but this not interpreted as a fault. This may be because the gear selector is between positions or that the gear-shift position sensor is incorrectly adjusted.
FAULT = the gear-shift position sensor has transmitted the wrong combination of signals and a diagnostic trouble code (DTC) has been stored.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
