2012 Volvo XC90 Base, AWDFACTORY OEM SERVICE PROCEDURE

Lock-Up Solenoid, SL

Fig 1: Identifying Lock-Up Solenoid, SL
GLL101517Courtesy of VOLVO CARS CORPORATION

Lock-up solenoid SL is positioned in the valve housing, which is mounted behind the side cover on the transmission. The lock-up solenoid consists of an electrical coil which controls a hydraulic valve. The solenoid is controlled by pulse width modulation (PWM) voltage and is grounded at the ground terminal. The solenoid controls lock-up engagement of the torque converter. Engagement occurs through solenoid pulsing which provides a smooth lock-up engagement function. Power transmission then changes to mechanical power transmission through the torque converter. The hydraulic function of the solenoid is linear.

There is a diagnostic for the electrical function of the solenoid, but not for the hydraulic function.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.