Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Passenger Airbag Indication
Supplemental restraint system module (SRS) transmits signals on the CAN network to the upper electronic module (UEM) if the front passenger airbag is activated or not. If the upper electronic module (UEM) receives information that the passenger airbag is deactivated, the upper electronic module (UEM) lights the passenger airbag warning lamp (PAD). The warning lamp is located in the upper section of the rear view mirror.
Depending on the market, if the switch for activating and deactivating the front passenger airbag is used to deactivate it, the passenger airbag disconnected (PAD) warning lamp lights.
The warning lamp goes out when the airbag is reactivated.
If an occupant weight sensor (OWS) is installed (market and model dependent), the passenger airbag disconnected (PAD) warning lamp lights when the airbag is deactivated. However there is an exception to this:
- The passenger airbag disconnected warning lamp will remain unlit if the occupant weight sensor (OWS) registers that the passenger seat is unoccupied. This means that the passenger airbag is deactivated.
The warning lamp goes out when the airbag is reactivated.
Reasons that the passenger airbag disconnected warning lamp lights may also be:
- communication problems between the supplemental restraint system module (SRS) and upper electronic module (UEM)
- faulty function in the on/off switch for the front passenger airbag
- defective occupant weight sensor (OWS) function.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
