2012 Volvo XC90 Base, AWDFACTORY OEM SERVICE PROCEDURE

Additional Heater/Parking Heater

Fig 1: Additional Heater/Parking Heater
GLL145810Courtesy of VOLVO CARS CORPORATION
  1. Control module
  2. Water pump
  3. Fan shroud
  4. Fuel pump (FP) (in front of the fuel tank)
  5. Heat exchanger

Gasoline driven vehicles can use a parking heater with timer function.

The additional heater/parking heater are positioned inside the front fenders, in front of the front left wheel arch.

The heater consists of:

  • the heater unit
  • the combustion preheater module (CPM)
  • the exhaust system
  • the air intake
  • the water pump.

The heater is connected to:

  • the engine cooling system
  • the vehicle fuel tank
  • central electronic module (CEM).

Both versions have a fuel pump (FP) located on the right-hand side in front of the fuel tank.

Vehicles with the parking heater function use the turn signal lamp stalk to control the heater. The information appears in the driver information module (DIM).

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.