2012 Volvo XC90 Base, AWDFACTORY OEM SERVICE PROCEDURE

Control Module Communication, Can/Most, Status

The status indicates which control modules on the MOST and LS-CAN networks the central electronic module (CEM) was able to communicate with when the diagnostic trouble code (DTC) was stored.

CEM OK = communication with the central electronic module (CEM), LS-CAN.

CEM nok = no communication with the central electronic module (CEM), LS-CAN.

AUD OK = communication with the audio module (AUD), MOST.

AUD nok = no communication with the audio module (AUD), MOST.

DIM OK = communication with the Driver Information Module (DIM), LS-CAN.

DIM nok = no communication with the Driver Information Module (DIM), LS-CAN.

DDM OK = communication with the Driver Door Module (DDM), LS-CAN.

DDM nok = no communication with the Driver Door Module (DDM), LS-CAN.

MMM OK = communication with the multimedia module (MMM), MOST.

MMM nok = no communication with the multimedia module (MMM), MOST.

PDM OK = communication with the Passenger Door Module (PDM), LS-CAN.

PDM nok = no communication with the Passenger Door Module (PDM), LS-CAN.

PSM OK = communication with the Power Seat Module (PSM), LS-CAN.

PSM nok = no communication with the Power Seat Module (PSM), LS-CAN.

SRS OK = communication with the Supplemental Restraint System Module (SRS), LS-CAN.

SRS nok = no communication with the Supplemental Restraint System Module (SRS), LS-CAN.

REM OK = communication with the rear electronic module (REM), LS-CAN.

REM nok = no communication with the rear electronic module (REM), LS-CAN.

SWM OK = communication with the steering wheel module (SWM), LS-CAN.

SWM nok = no communication with the steering wheel module (SWM), LS-CAN.

CCM OK = communication with the Climate Control Module (CCM), LS-CAN.

CCM nok = no communication with the Climate Control Module (CCM), LS-CAN.

UEM OK = communication with the upper electronic module (UEM), LS-CAN.

UEM nok = no communication with the upper electronic module (UEM), LS-CAN.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.