2012 Volvo XC90 Base, AWDFACTORY OEM SERVICE PROCEDURE

Oil Pressure And Temperature Sensor

Fig 1: Identifying Oil Pressure And Temperature Sensor
GLL146175Courtesy of VOLVO CARS CORPORATION

The oil pressure and temperature sensor is fitted close to the axial solenoid in the Differential Electronic Module (DEM) housing. The sensor is flushed with hydraulic oil. The sensor measures the temperature and pressure (measurement range 0 - 4 MPa) of the hydraulic oil. The sensor sends a signal on temperature and pressure to the control module. The control module uses the signal to adapt the function of the system when the temperature of the oil and its subsequent viscosity is changed.

If the temperature of the oil exceeds 105 Β°C then the clutch is depressurized and four-wheel drive is disconnected. When the temperature falls below 101 Β°C the clutch is pressurized again. The pressure of the oil is limited to max. 10.3 MPa by the safety valve.

Four-wheel drive does not function in the event of any fault in the temperature sensor, and the function is significantly reduced in the event of a fault in the pressure sensor.

The oil pressure and temperature sensor can be diagnosed.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.