Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Volvo XC90 Base, AWDFACTORY OEM SERVICE PROCEDURE
RTI Control Module
Before taking any readings, see CONNECTING THE BREAKOUT BOX AND CHECKING THE GROUND TERMINAL .
The RTI control module terminals A1-A22 correspond to terminals #1-#22 on the breakout box.
| Control module terminal | Breakout box terminal | Signal type | Ignition on | Other |
|---|---|---|---|---|
| A1 | #1 | 30-supply (power supply from battery) | Ubat | - |
| A2 | #2 | - | - | - |
| A3 | #3 | - | - | - |
| A4 | #4 | - | - | - |
| A5 | #5 | - | - | - |
| A6 | #6 | - | - | - |
| A7 | #7 | Signal (+) with map information from the CD-ROM changer | Digital signal | VH
=0.68 +/- 0.2 V, VL =0.5 +/- 0.1 V |
| A8 | #8 | - | - | - |
| A9 | #9 | - | - | - |
| A10 | #10 | CANH signal | U = 2-3 V | - |
| A11 | #11 | Ground (Measured to battery negative terminal) | Ulow | - |
| A12 | #12 | - | - | - |
| A13 | #13 | - | - | - |
| A14 | #14 | - | - | - |
| A15 | #15 | - | - | - |
| A16 | #16 | - | - | - |
| A17 | #17 | - | - | - |
| A18 | #18 | - | - | - |
| A19 | #19 | Signal (-) with map information from the CD-ROM changer | Digital signal | VH
=0.68 +/- 0.2 V, VL =0.5 +/- 0.1 V |
| A20 | #20 | Screen ground, signal cables to CD-ROM changer | Ulow | - |
| A21 | #21 | - | - | - |
| A22 | #22 | CANL signal | U = 2-3 V | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
