Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Signal Specification, Power Steering Control Module (PSCM)
GeneralÂ
All values listed below should be measured between the respective terminal (column 1, Terminal control module) and power ground (terminal B2) unless stated otherwise in the column Miscellaneous.
There is no cable harness on the Power Steering Control Module (PSCM) for connecting the breakout box. It is therefore important when any measurements are carried out that great care is taken to prevent short-circuits and damage to connectors.
| U= | DC voltage in volts (V) | UAC = | AC voltage in volts (V) |
| Ubat = | Battery voltage in volts (V) | f = | Frequency in Hertz (Hz) |
| Ulow = | Voltage approximately 0 V | PWM = | Pulse width modulated signal in % |
| t = | Time in seconds (s) | I = | Current in amperes (A) |
| Control module terminal | Breakout box connection | Signal type | Ignition on | Engine idling | Miscellaneous |
| #A1 | - | Relay 15-feed, voltage feed | U = Ubat | U = Ubat | Ignition off: U = Ulow |
| #A2 | - | HS-CAN L | - | - | Â |
| #A3 | - | HS-CAN H | - | - | Â |
| Control module terminal | Breakout box connection | Signal type | Ignition on | Engine idling | Miscellaneous |
| #B1 | - | 30-supply (power supply from battery) | U = Ubat | U = Ubat | Ignition off: U = Ubat |
| #B2 | - | Power ground | U = Ulow | U = Ulow | Ground terminal, connected to the chassis |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
