2012 Volvo XC60 T-6 R-DesignFACTORY OEM SERVICE PROCEDURE

Control Module

GLL1037201Courtesy of VOLVO CARS CORPORATION

The supplemental restraint system module (SRS) handles functions for:Β 

  • belt tensioners
  • side impact sensors
  • front collision sensor (not XC60)
  • seatbelt retractor sensor (only XC60 or USA/CDN).
  • seat position sensors (USA/CDN only)
  • adaptive seatbelt force limiter (only XC60 or USA/CDN)
  • side airbags
  • front airbags
  • inflatable curtains
  • SRS indication
  • passenger airbag indication
  • collision output signal
  • collision registration
  • adaptive steering column (USA/CDN only)
  • front belt buckle detection
  • rear belt buckle detection (certain markets only)
  • internal CAN, supplemental restraint system module (SRS)
  • occupant weight sensor (OWS) (USA/CDN only)
  • switch airbag passenger front (not USA/CDN).
  • roll-over sensor (only XC60)

The control module is located under the cup holder in the tunnel console.

The supplemental restraint system module (SRS) communicates on the CAN with both directly connected components and other control modules. In certain markets, the control module can also communicate with components via an internal CAN.

The control module checks the input and output signals through an integrated diagnostic system. A diagnostic trouble code (DTC) is stored if the control module detects a fault.

Any diagnostic trouble codes are stored in the control module memory. The data can be read off using the diagnostic tool.

The control module can handle frontal collisions, side collisions, collisions from behind, and roll-overs (only XC60).

A simple way to check that the SRS system is functional is to switch the ignition to position II. The SRS warning lamp in the driver information module should light when the ignition is switched to position II. If no faults are detected, the warning lamp goes out after a short delay. This means that the SRS system is fully functional and fault-free.

For further information, also see SIGNALSΒ .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.