2012 Volvo XC60 T-6 R-DesignFACTORY OEM SERVICE PROCEDURE

Rear-End Collision

USA/CDN 

GLL1039226Courtesy of VOLVO CARS CORPORATION

Other 

GLL1031800Courtesy of VOLVO CARS CORPORATION

In the event of a rear-end collision, the supplemental restraint system module (SRS) (4/9) evaluates the force of the collision pulse. If the collision pulse is powerful enough, a deployment signal (current pulse) is sent to the front belt tensioners (8/33 and 8/34) and the front waist belt tensioner (8/92) (certain markets only). The belt tensioners are deployed.

The Supplemental restraint system module (SRS) also transmits an impact signal on a directly connected cable to the Central electronic module (CEM) (4/56) and Phone module (PHM) (16/60) (not USA/CDN) when the impact protection has been activated.

A collision status signal is also sent to the central electronic module (CEM) and phone module (PHM) (not USA/CDN) on CAN. These two control modules make sure that:

  • switch off the fuel pump (FP)
  • switch off the windshield wipers when the car is stationary
  • turn off defrosting of windows and rearview mirrors if the vehicle is stationary
  • light the interior lighting
  • light the flashing hazard lights
  • unlock the central locking system
  • send an automatic alarm to CSC (Customer Service Center) when an accident has occurred - provided the vehicle is equipped with Volvo On Call (Plus).
  • turn off the fuel engine heater
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.