2012 Volvo S60 T-6FACTORY OEM SERVICE PROCEDURE

Input Speed

The value displays the input speed (RPM). With the engine at idle speed and the gear selector lever in P/N position the speed (RPM) can be generated. If the gear selector lever is in another position a gear is engaged and the transmission input shaft engages with the output shaft. The speed (RPM) is displayed when the vehicle is driven. Depending on the slippage in the torque converter the transmission speed (RPM) and the engine speed (RPM) will differ when lock-up is not engaged. With lock-up engaged the transmission speed (RPM) must be the same as the engine speed (RPM).

Measurement range: 0 - 65 535 RPM.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.