2012 Volvo S60 T-6FACTORY OEM SERVICE PROCEDURE

Description Of Frozen Values, Transmission Control Module (TCM): General

Frozen values are parameter values that are stored when a diagnostic trouble code (DTC) is stored. Not all the parameters described need to be implemented in the control module. This varies from system to system. Parameters can also vary depending on with which type of transmission the vehicle is equipped.

Certain parameters can be displayed without a value or with unreasonable values. This can occur if the control module has not stored a value, when a basic value has been stored instead or if the parameter is received via CAN when there is an error on CAN. For example, the RPM values may be unreasonable if a malfunction occurs on the transmission's speed sensors.

Definition of an operating cycle 

The definition of an operating cycle varies depending on the software version, as follows:

  • Ignition switched off, then switched on and finally switched off again
  • Ignition switched off, the engine started and finally the ignition switched off again
  • Ignition switched off, engine started, driven at a speed above 30 km/h for more than 3 minutes and finally the ignition switched off again.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.