Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Parameter, Status
POWER SUPPLY POSITIONÂ
The value indicates the status of the power supply mode.
- Key removed
- Key recently removed
- Key approved
- Ignition off after Accessory position
- Accessory position
- Accessory position after Ignition on
- Ignition on
- Running
- Start attempts
THROTTLE UNIT ADAPTATIONÂ
If necessary the Engine Control Module (ECM) runs an adaptation of the throttle unit by guiding the throttle to the limit positions (open/closed) so that it " learns" the parameters of that actual throttle unit.
The status indicates if the adaptation has been run or not.
OK = Adaptation of the throttle unit has run.
NOT OK = Adaptation of the throttle unit has not run.
The basic conditions must be met before an adaptation of the throttle module can be carried out.
POSITION GEAR SELECTORÂ
Only vehicles that have an automatic transmission.
The Engine Control Module (ECM) calculates the status of the signal from the directly connected cable from the Transmission Control Module (TCM).
P/N engaged = gear selector position is in "Park" or "Neutral".
P/N disengaged = gear selector position is not in "Park" or "Neutral".
POSITION GEAR SELECTOR (VIA CAN)Â
Only vehicles that have an automatic transmission.
the Engine Control Module (ECM) calculates the status of the signal from the Transmission Control Module (TCM) via CAN.
P/N engaged = gear selector position is in "Park" or "Neutral".
P/N disengaged = gear selector position is not in "Park" or "Neutral".
CRANK SIGNALÂ
The parameter shows if Engine Control Module (ECM) requests activation of the starter motor relay. In turn, the relay activates the starter motor.
IMMOBILIZER, START ALLOWEDÂ
YES = The immobilizer allows start up
NO = The immobilizer does not allow start up
CLUTCH PEDAL POSITION SENSORÂ
Measurement range 0 - 100 %.
The Engine Control Module (ECM) receives the value for the clutch pedal position sensor signal from the Central Electronic Module (CEM) via CAN communication.
The value indicates the clutch pedal position.
0 % = released clutch pedal.
100 % = Clutch pedal pressed down.
CLUTCH PEDAL SWITCHÂ
Engine Control Module (ECM) receives the value for the clutch pedal switch.
The value indicates the clutch pedal position:
Clutch pedal pressed down.
Released clutch pedal.
BRAKE LIGHT SWITCHÂ
The Engine Control Module (ECM) calculates the value from the directly connected signal from the brake light switch.
ON = brake light switch on.
OFF = brake light switch unaffected.
AIR CONDITIONING (A/C) COMPRESSOR, STATUSÂ
The signal transmitted by the Engine Control Module (ECM) for activating the air conditioning (A/C) compressor relay.
OFF = The Engine Control Module (ECM) does not activate the air conditioning (A/C) compressor relay.
ON = The Engine Control Module (ECM) activates the air conditioning (A/C) compressor relay.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
