2012 Volvo S60 T-6 R-DesignFACTORY OEM SERVICE PROCEDURE

Vacuum Sensor 7/160

GENERAL 

Type 

Vacuum pressure sensor: Double piezoresistive sensors

The sensor measures the pressure change between the vacuum chamber and the work chamber. The signal ratio between the chambers should correspond.

characteristic 

Vacuum chamber (1): Voltage between terminals #30 (#A30) and #40 (#A40) should be similar to diagram 1 below.

Work chamber (2): Voltage between terminals 41 (A#41) and #40 (#A40) should be similar to diagram 2 below.

GLL1002899Courtesy of VOLVO CARS CORPORATION

PEDAL PRESSURE SENSOR/CHECK VALVE (SAME CONNECTOR) 

Type 

Pedal pressure sensor: Two-pin, quickshifter located within the brake servo on the brake servo pushrod

Check valve: Electric coil with magnet core and valve

Characteristic pedal pressure sensor 

Resistance between terminals #1 and #5 should be infinite when the brake pedal is not actuated and 0 Ω when the brake pedal is depressed

Resistance between terminals #2 and #5 should be 0 Ω when the brake pedal is not actuated and infinite when the brake pedal is depressed

Characteristic, check valve 

Resistance between terminals #3 and #4 should be approx. 3 Ω.

Check, pedal pressure sensor 

Prerequisites (unless otherwise specified):

Check 

  • Breakout box connected
  • Sensor connected
  • Ignition switch position II

Check 1, pedal pressure sensor 

Voltage between terminals #21 (#A21) and #23 (#A23) should be 0 V when the brake pedal is not actuated and 12 V when the brake pedal is depressed.

Voltage between terminals #21 (#A21) and #24 (#A24) should be 12 V when the brake pedal is not actuated and 0 V when the brake pedal is depressed.

Check 1, check valve 

Voltage between terminals #17 (A#17) and #31 (#A31) should be 12 V.

GLL104186Courtesy of VOLVO CARS CORPORATION
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.