2012 Volvo C70FACTORY OEM SERVICE PROCEDURE

Washer System

Washer nozzle 

There are also washer nozzles on the hood and bumper cover for cleaning the windshield and headlamps.

The check valve in the windshield washer nozzle prevents windshield washer fluid from flowing back into the system.

Vehicles with three or five doors also have a jet to clean the rear window.

Washer pump 

There are two different types of washer pump.

The monopump is used for washing the windshield (2 and 4-door models).

The dual pump is used for washing both the windshield and the rear windshield (3 and 5-door models). The pump is double acting. The dual pump changes direction when rear windshield washing is activated, washing though the rear windshield washing outlet.

High pressure pump 

The high pressure pump is used for headlamp wash / wipe.

Level sensor 

The central electronic module (CEM) monitors the washer fluid level in the washer can using the level sensor. The switch in the level sensor gives a signal when the level is below 0.7 liters. A text message indicating that it is necessary to fill with washer fluid is displayed in the driver information module (DIM).

The headlamp washers are not activated if the level in the washer can is lower than 0.7 liters.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.