Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Reading Off The Parameters
Data can be read off from the trailer module (TRM) using this function.
Battery voltage
Reads off the level of the power supply to the control module.
Input signal
Reads out the status of the stop lamp signal from the vehicle's right tail lamp.
Output signals
Reads out the status of the output signals to the cable harness for the tow hitch.
Tow hitch connector
Reads out whether the tow hitch connector is connected to the socket on the cable harness for the tow hitch.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
