Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Key Warning
The key warning function is part of the security system (applies to USA/CAN only). The components in the function are the central electronic module (CEM) and the driver information module (DIM). The warning is activated if the driver's door is opened while the key is in the ignition switch. A contact breaker in the lock unit in the driver's door indicates that the door has been opened.
If the system for keyless functions is installed, the antennas inside the vehicle are activated each time the driver's door is opened. The system then scans for the key which was used to start the vehicle. A warning message is displayed in the driver information module (DIM) if this key is not found. The engine will continue running, but if the key is turned to position 0 the engine will not start again if there is not another valid key inside the vehicle.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
