2012 Volvo C70FACTORY OEM SERVICE PROCEDURE

Switch For Opening/Closing The Roof

Fig 1: Switch Opening/Closing The Roof
GLL150691Courtesy of VOLVO CARS CORPORATION

The switches for operating the roof are located on the transmission tunnel in the passenger compartment.

The switches are directly connected to the Convertible Roof Module (CRM). The Convertible Roof Module (CRM) receives signals from the switches to start roof operation after all necessary checks are made.

When operating the roof for opening/closing, the switch must be held depressed so that the roof opens/closes.

The functions of the switches:Β 

  • open the roof
  • close the roof.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.