Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Tank System
Testing for leakage in the fuel tank system is running. During the first half of the test, major leaks (leaks larger than 1.0 mm) can be detected. Diagnostic trouble code (DTC) is stored in the engine control module (ECM) if leakage is detected.
After a certain amount of time (time is dependent on the fuel level in the tank) the engine control module (ECM) assesses the seal of the fuel tank system. Assessment is made using the results of the calculations of time, measured reference power consumption of the pump, measured power consumption of the pump during the time of assessment and from the shape of the power supply curve and characteristics during pressurization. If the leak in the fuel tank system is larger than 0.5 mm but smaller than 1.0 mm a diagnostic trouble code (DTC) is stored for minor leakage in the engine control module (ECM).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
