Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Volvo C70FACTORY OEM SERVICE PROCEDURE

Component Locations - C70

Select a section or procedure below to view factory instructions:

Accessory USB Unit (AUU) - Component Location Central Electronic Module (CEM) - Component Location Accessory Electronic Module (AEM) - Component Location Climate Control Module (CCM) - Component Location Combustion PREHEATER Module (CPM) - Component Location Climate Unit - Component Location Auxiliary Heater, Fuel Operated - Component Location Convertible Roof Module (CRM) - Component Location Engine Compartment - Component Location Parking Assistance Module (PAM) - Component Location Washer Reservoir - Component Location Keyless Vehicle Module (KVM) - Component Location Headlights (Bi-Xenon) - Component Location Headlights - Component Location Headlamp Control Module (HCM) - Component Location TAILLAMP - Component Location Infotainment - Component Location Integrated Audio Module (IAM) - Component Location Traffic Message Channel Module (TMC) - Component Location Subwoofer Module - Component Location Global Positioning System Module (GPS) - Component Location Infotainment Control Module (ICM) - Component Location Remote Digital Audio Receiver (RDAR) - Component Location Multimedia Module (Mmm) - Component Location Audio Module (AUD) - Component Location Phone Module (PHM) - Component Location BLUETOOTH Phone Module (Bpm) - Component Location Power Seat Module Right/Left (PSR/PSL) - Component Location Steering Wheel Module (SWM) - Component Location Electrical Power Steering Module (EPS) - Component Location Supplemental Restraint System (SRS) - Component Location Trailer Module (TRM) - Component Location

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.