2012 Volvo C70FACTORY OEM SERVICE PROCEDURE

Diagnostic Trouble Code (DTC) Information PHM-E001

Condition 

The control modules transmit and receive information via a standardized serial communication method - CAN (Control Area Network).

The diagnostic trouble code (DTC) is stored if the control module detects that:

  • Serious interference on the low-speed network is registered, CAN communication blocked.
NOTE:

In the event of communication faults in the system, the Phone module (PHM) cannot be communicated with. Therefore it will only be possible to read off the fault if it is intermittent.

The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.