2012 Volvo C30 T-5 R-Design, Automatic TransFACTORY OEM SERVICE PROCEDURE

Collision Warning Control Module: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2013 Volvo C70, 2012 Volvo C70, 2011 Volvo C70, 2010 Volvo C70, and 2009 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Removal steps in this procedure may contain installation details.

Remove the combined instrument panel, see COMBINED INSTRUMENT PANEL

Fig 1: View of Collision Warning Control Module
GLL162576Courtesy of VOLVO CARS CORPORATION

Torque:Β  M6

10 Nm

Fig 2: Removing Collision Warning Control Module
GLL162577Courtesy of VOLVO CARS CORPORATION
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.