Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Alarm Signal Outputs
An external (aftermarket) alarm unit can be connected to the accessory electronic module (AEM). The system consists of four output signals that via a cable harness can be used as input signals in the external alarm system. The accessory electronic module (AEM) uses the existing CAN-network to receive/transmit signals that describe the car's alarm, key, and door status.
When installing an after market alarm system the car must be configured using new software. Configuration is carried out via VIDA (Volvo scan tool).
There are diagnostics for the alarm signal outputs.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.