Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Volvo XC70 T-6FACTORY OEM SERVICE PROCEDURE
Exploded View Of The Starter Motor
The starter motor consists of:
- Drive cover.
- Gear wheel.
- Solenoid.
- Battery terminal.
- Rear end and bearing.
- Carbon brush holder and carbon brushes.
- Commutator.
- Armature.
- Permanent magnet or field winding.
- Armature housing.
- Planetary train.
- Lever with freewheeling clutch.
- Pinion engaging drive.
NOTE:
Starter motor for V8 engine and DV6 S/S is equipped with field winding instead of permanent magnets. The field windings are electrically connected in series by carbon brushes.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.