Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Volvo S60FACTORY OEM SERVICE PROCEDURE
Engine, General - Design And Function
- Engine
- Engine [2011-2016, B6304T4 | 2015-2016, B6304T5]
- Notes
- Overview
- Design And Function
- Engine Block
- Cylinder Head, Camshaft Bearing Housing
- Cylinder Head Gasket
- Cylinder Block
- Oil Sump And Oil Volume
- Oil Scraper Plate
- Piston
- Spark Plugs
- Crank System
- Intermediate Shaft
- Camshaft Transmission
- Variable Camshaft Profile (Cps), Only Applies To B6324S5
- Valve Depressor
- Lubrication System
- Cooling System
- Crankcase Ventilation
- Auxiliary Unit Transmission
- Turbocharger (TC)
- Exhaust Manifold / Catalytic Converter
- Engine [2013-2016, B5254T12 | 2011-2012, B5254T5]
- Engine [2014-2015, B4204T10 | 2014-2018, B4204T11; B4204T12; B4204T9 | 2017-2018, B4204T43]
- Design And Function
- Component Location
- VOLVO'S Drive-E Engines
- Valve System And Timing Gear
- Drive Belt Routing (B4204T9, B4204T10)
- Drive Belt Routing (B4204T12/T13/T15, D4205T5)
- Oil System
- Fuel System
- Fuel Pressure Sensor
- Direct Injection
- Air Intake And Exhaust System
- Turbocharger
- Exhaust After-Treatment
- Cooling System
- Engine Management System
- Design And Function
- Engine [2011-2016, B6304T4 | 2015-2016, B6304T5]
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.