Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ranking Values
There are ranking values for each diagnostic trouble code (DTC). A ranking value is a counter that indicates how close to storing a diagnostic trouble code (DTC) the system considers itself to be for each diagnostic function, in relation to a component or function. The counter counts upwards when the fault is active and downwards when the fault is not active (A).
When the ranking value exceeds a certain level, normally 128, a reconfiguration is performed where substitute values are activated in the system (B).
HINT: Read more about the substitute values for the diagnostic trouble codes (DTCs) in the Information Manager, under each the information for each diagnostic trouble code (DTC).Β
When the ranking value exceeds a further level, normally 255, a diagnostic trouble code (DTC) is stored (C).
HINT: For certain functions, a diagnostic trouble code (DTC) is stored at the same time as the substitute value is activated, i. e. at ranking value 128. For other functions the counter continues to 255 before a diagnostic trouble code (DTC) is stored.Β
The ranking information consists of two values:
- "Latest" indicates the ranking value at read out
- "Worst" indicates the highest ranking value the diagnostic trouble code (DTC) has reached.
These parameters are reset when diagnostic trouble codes (DTCs) are erased or when the power is to the control module is cut.
HINT: By comparing "Latest" with "Worst", it is often possible to determine whether the fault is permanent or intermittent. Low "Latest" and high "Worst" indicates an intermittent fault.Β
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
